VIAIR’s Constant Duty Onboard Air System is a pre-packaged compressed air solution that provides a 100% duty cycle compressors, a 2.5 gallon air tank, and all components needed to install a working system capable of inflating tires.
Please Note: Pressure Switch w/Relay (PNs 90110, 90111, 90113, 90118) is not a sealed unit and should be installed in an area protected from the elements to prevent damage and/or failure.
Use thread sealant for proper installation. Thread tape is not recommended. Properly sealed, recommended torque for 1/8″ is 10 ~ 11 ft. lbs. Recommended torque for 1/4″ and 3/8″ is 12 ~ 15 ft. lbs.
| Features |
Specifications |
| 2.5 Gallon VIAIR Air Tank |
12-Volt |
| 450C VIAIR Compressor |
Permanent Magnetic Motor |
| 35ft. Coil Hose with Tire Chuck |
Duty Cycle: 100% @ 100 PSI |
| Dash Panel Gauge with ON/OFF Switch |
Max. Working Pressure: 150 PSI |
| Pressure Switch with Relay (110 PSI on, 145 PSI off) |
Max. Amp Draw: 23 Amps |
| Reducer: 1/8” (F) to 1/4” (M) |
Ingress Protection Rating: IP67 |
| 1/4” Quick Connect Stud (F) |
|
| 1/4” Quick Connect Coupler (F) |
|
| 1/4” 175 PSI Safety Valve |
|
| 1/4” Drain Cock |
|
| (3) 1/4” Compression Fittings |
|
| 20ft. 12-Gauge Wire with Inline Fuse Holder |
|
| 4” Strip of Continuous Grommet Material |
|
| Accessory Airline |
|
| Electrical Connections |
|
All Fittings are NPT rated unless otherwise noted.
